The soft top seat belt bar is designed to allow for easy fitting of 3 or 4 point inertia seat belts that no longer have a high mounting point available, especially if you have converted from a hard top to a soft top. To install, simply locate the outer flat plates onto the top body capping as shown in images below and line up the rear bar with the side capping point. Drill and bolt into place either side to create a top mounting. If you require a new seat belt you will need a 4 door front inertia belt to do this job properly and NOT a 2 door belt. The brackets you require are correct on the 4 door inertia belt.The inertia reel mounts to the lower point and shown with the top buckle above. This is a great kit and offers a very easy way to convert seat belts safely when modifying your vehicle without the need to install a roll bar if not required (fitting time for bar is about 30 min). Please note that the horizontal bar may interfere with the positioning of the spare wheel behind the bulkhead if fitted, You may need to pack the spare wheel out or change it's location. Available for viewing at The Exmoor Trim Showroom now open.
(Separate labour fitting charge would apply). The item "Land Rover Defender or Series Soft Top Front Seat Belt Bar Exmoor" is in sale since Wednesday, March 10, 2021.
This item is in the category "Vehicle Parts & Accessories\Car Parts\Other Car Parts". The seller is "exmoortrim" and is located in Taunton, Somerset. This item can be shipped worldwide.