Land rover series 3 1 ton

  
It is completely stripped to bare chassis again, land rover series 3 genuine 1 ton 6cyl ex seb ive now'n of this land rover 32 years! I have owned it approx 13 years, the guy i bought if from owned it 19 years, and only used it for light use, and i know the owner well, i bought it with the intenstion of just giving it a quick make over but as i got inn to it ended up doing it all well almost! Engine rebuilt & detailed, original chassis two outriggers and Xmemeber repaired. Is completely stripped not as it in pics right down to bare chassis and will need completely reassembling chassis will need painting and prep work also axles will now need painting again to freshen them up again??????????????????? It has a standard ratio gearbox, so when completed will do motorway speed, as you can see i was doing this as a period breakdown truck, i have a correct harvey frost all shot blasted and paint red to match the bumper, the truck cab is a one off roof was going to make chariot side to flow from the back of this hence the rear of cab being straightened of, this when completed could be the best in the country, all galvinesd parts redone including door frames and bonnet frame, new seats, good second hand top and lower dash panels with no splits, anty burst door locks, 90/110 alloy door tops all painted same green, i have many new parts to go on this so many i cant remember them all, but i wanted this to be the best so i made sure what i did was done to a good standard you can have every part ive got for it, even have deluxe cab headliner for it, i have now'n this land rover and its owner since i was 12 or 13, im now 45, its an ex seb was a plain sided hard top, the man i bought it from used it for light use only, i had plans of having it sign writtern above the cab and down the sides traditonally painted! No sticker rubbish on my truck, and use it as a work truck! A every part on this land rover was painted sepperatly and ether replaced or rebuilt, every part of this was taken back to bare metal, no stone chip no fibbre glass no shults no bodge, the chassis was shot blasted primed but left, so now you will need to prep chassis and prep axles, rope was left in chassis to pull loom back through after spraying! The axles are complete with springs hubs etc, when i stripped again i did it in chunks, wings, rear tub, doors, roof, bulkhead complete with loom, exhaust, fuel tank, engine complete, gearbox etc etc, ALL THAT NEEDS DOING IS PREP CHASSIS FOR PAINT REPAINT AXLES, AND THEN PUT IT ALL BACK TOGETHER , EVERY OTHER PART HAS BEEN DONE TO A HIGH STANDARD. ALL PANELS HAVE BEEN STORED VERY VERY CAREFULLY NOT ONE ITEM IS SCRATCHED!!!!!!!!!!!!!!! CHASSIS NUMBER IS 26600183C, REG IS JTR506P ITS IS NOW'N ON THE 1 TON FORUM. The item "Land rover series 3 1 ton" is in sale since Sunday, July 03, 2016. This item is in the category "Cars, Motorcycles & Vehicles\Classic Cars\Land Rover". The seller is "twinworty40" and is located in Alresford. This item can be shipped to United Kingdom.